Wing Mount - Compatible w/ Traxxas X-MAXX

Transform your X-Maxx with our sleek wing mount kit — the perfect finishing touch for a standout build. Designed for easy installation while weighing under 12oz (more than half of which is the XRT Wing itself), this durable mount kit lets you run a full-size XRT wing with a clean, aggressive look that will help bring your setup together.

Installation Guide

Tools & Parts Needed:

- 1/8" drill bit

- 2.5mm Hex Bit

- XRT Wing (TRA7821)

- 5.5 mm & 7mm Hex Bit(s) or Pliers (optional)

Included Hardware:

- M3x20 screws + M3 nuts = 4x

- M4x12 screws + M4 nuts = 6x

- M4x35 screws = 4x

Step 1: Remove Stock Tailgate Protector

Remove the factory X-Maxx tailgate protector (Part #TRA7712). You won’t need the exterior piece or its screws, so set them aside.

Step 2: Modify Inner Tailgate Piece

Cut or split the inner section of the tailgate protector as shown in the photos (Cut should be approx. 115mm centered). Do not cut the body itself. Set the center section aside. 

Step 3: Install Tailgate Base

Align the 3DA tailgate base with the peg holes in the X-Maxx body. Using the two end pieces from Step #2, Secure 3DA Tailgate base in place using the provided M3x20 screws and M3 nuts. (screw orientation up to user)

**Verify Tailgate is secured 100%(no gaps) to body before moving to Step 4**

Step 4: Drill Mounting Holes

You’ll see 5 pre-marked holes in the 3DA tailgate base that align with the X-Maxx body (2 on top and 3 on the rear). Use a 1/8" drill bit to carefully drill out each of these holes. 

Step 5: Attach Wing Mount

Align the holes in the wing mount with those on the tailgate base (Refer to photos for orientation). Secure them together using the included 5x M4x12 screws and M4 nuts:
- 2 screws go upward and outward (Last two photos)
- 3 screws go in from the rear (Last two photos)

Tip: Use a 7mm hex bit or pliers to hold the interior M4 nuts in place during installation(refer to photos).

Step 6: Mount XRT Wing

Attach your XRT wing to the wing mount using the provided M4x35 screws. Tighten securely. Enjoy!

If you experience locknuts pushing out/rotating during installation, backtrace screws, re-insert the locknuts and re-try again slowly!

What separates us from the competition? Simple, we use state of the art technology and years of expertise to ensure the best quality and strength for you! We design and test our mounts to ensure the best durability. Always taking custom requests! If you don't see it, let us know and we can work towards turning your idea into a reality!